Installation instructions • Read online or download PDF • Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual. Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual – Download. Rockwell Automation IF8 Compact IF8 Analog. The Compact I/O modules can be used with a CompactLogix controller, IF4FXOF2F. IF8. IF16C. IF16V. IR6. IT6.

Author: Tygoshicage Yozshuran
Country: Netherlands
Language: English (Spanish)
Genre: Relationship
Published (Last): 3 February 2010
Pages: 281
PDF File Size: 20.93 Mb
ePub File Size: 16.3 Mb
ISBN: 880-5-39562-772-3
Downloads: 54786
Price: Free* [*Free Regsitration Required]
Uploader: Voodoobei

Wire fragments that fall into a module could cause damage at power up.

Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual | Page 10 / 32

Use M4 or 8 panhead screws. Or point us to the URL where the manual is located.

Input Data File Word For each input module, slot x, words in the input data file contain the analog values of the inputs. This lets you individually cancel each low process alarm latch. To allow communication between the controller and module, move the bus lever fully to the left 4 until it clicks.


Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual | 32 pages

For More Inform ation Don’t see a manual you are looking for? Attach an end cap terminator 5 to the last module in the system by using the tongue-and-groove slots as before.

Route the wire under the terminal pressure plate. NC Wiring for channels are identical.

However, some systems, like the ADN DeviceNet Adapter, also allow the bits to be altered as part of the control program, using communication rungs. The terminals will accept a 6.

Channel 0 and 1 Configuration Data Channel 0 and 1 configuration data is shown below. Ensure it is locked firmly in place. Remove the label from the door, mark the identification of each terminal with permanent ink, and slide the label back into the mmanual. Locate holes every Tell us what’s missing. Loosen the terminal screws to be wired. Mounting screws are required on every module.

Replacing a Single Modu le within a System You can use the bare wire or a spade lug. Use a power supply that matches the input transmitter specifications. Overall hole spacing tolerance: Approximate Shipping Weight with carton g 0.


Lock the end cap bus terminator 6.

Host Controller Spacing for single-wide modules 35 mm 1. Your manual failed to upload Tell us about it. In that case, graphical screens are provided by the manuwl to simplify configuration. The terminal screws are non-captive.

Rockwell Automation 1769-IF8 Compact 1769-IF8 Analog Input Module User Manual – Download

The latches will momentarily open and lock into place. Your markings ID tag will be visible when the module door is closed. Rockwell Automation Support Rockwell Automation provides technical information on the web to assist you in using our products.

The same information applies to all channels.