Above values from ASTM A Higher strengths can be produced by heavy cold work – this may be required for certain applications. ASTM A – 16 Standard Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging. This specification covers. See the chemical composition and physical properties of ASTM A Grade annealed Stainless Steel, find alternative materials, and connect with suppliers.
|Country:||Turks & Caicos Islands|
|Published (Last):||8 October 2018|
|PDF File Size:||15.20 Mb|
|ePub File Size:||14.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
Copyright ASTM Standard Specication for A43 Steel Wire and Wire Rods for Cold Heading and Cold Forging1 This standard is issued under the xed designation A ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval.
A superscript epsilon e indicates an editorial change since s493 last revision or reapproval.
This standard has been approved for use by agencies of the Department of Defense. The SI equivalents are in parentheses and may be approximate.
Such requirements may include, but are not limited to the following: General Requirements for Delivery 4. Current edition approved Jan. Originally published as A — Last previous edition A — NOTE 1—A typical ordering description is as follows: An electroplated copper coating is often used. The following coatings may be specied: Soap is generally used.
ASTM A for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging
The following lubricants may be specied: B Product analysis tolerance over the maximum limit for carbon and nitrogen xstm be 0. Material can be manufactured to tensile strength ranges other than those shown in Table 2. The producer should be consulted when material w493 required to tensile strength ranges other than those specied. For smaller sizes, similar mechanical properties apply to ferritic and martensitic grades; however the producer should be consulted regarding somewhat higher tensile properties applicable to austenitic grades.
Resistance to Intergranular Corrosion 8.
Packaging and Package Marking 9. The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. This standard is subject to revision at any time z493 the responsible technical committee and must be reviewed every ve years and if not revised, either reapproved or withdrawn.
Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. Your comments will receive careful consideration at a meeting of the responsible technical asym, which you may attend.